Twin pen dental sandblater with drawer

Specification

Model: AZ-DE38

Voltage: AC110~240V 

Power: 500W

Frequency: 50/60Hz

Sand particle size: ≥ 120 mesh

intake pressure: 0.3-0.4Mpa

Particles Size: 120um/50um

Parts Included

Manual × 1

Nozzle × 3

Lighting Tube × 1

Fuse × 2

Air Pipe × 1

Dust Pipe × 1

Aluminum oxide × 1

Korean pencil × 2 (Optional)

Korean nozzle × 2 (Optional)

Features of dental sandblasting machine

(1) This machine is a dental professional essential equipment, mainly used for removing a variety of small surface oxide things.

(2) Casting for the surface of the plastic base plate glass beads .

(3) The body material is cold-rolled steel, durable; cabinets have lights, easy to operate.

(4) with a tool drawer, can be used for storing finishing mechanic tools.

Installation method of dental sandblasting machine

1. Poor sand production. Please check if the pressure reaches 4kg or above, adjust the pressure regulating valve first, and then check if there is too much or too little sand poured into the container.

 When the pressure gauge shows pressure but the pen does not sand, it is already blocked. Please unscrew the locking nut in front of the pen holder for cleaning, then press the foot switch to supply air, and finally tighten the locking nut. 

2. During the use of the equipment, it is necessary to pay attention to the cleaning of dust at all times, otherwise it may cause poor contact of the electrical parts and affect normal use. 

3. The amount of sand in the sand storage tank should not exceed half of the tank's capacity to achieve the best results. 

4. Used sand should not be reused to prevent blockages in the air path

Usage of dental sandblasting machine

1. Firstly, tighten and secure each pipe joint. 

2. Insert the power cord and foot switch cord into their respective sockets, connect the power supply, 

3. Unscrew the two sand cup covers and pour in sand, preferably at half the height of the jar, otherwise it will affect the sandblasting effect. 

4. Step on the foot switch, adjust the pressure regulating valve, and the machine can only

operate when the pressure is greater than 4 kg. Adjust the directional control to sand the left and right pens. 

5. When cleaning the sand inside the machine, unscrew the screw directly below and lift the machine upwards. The sand will naturally flow out from the screw hole.